Hoverboard Not Charging: Causes, Fixes & Prevention Guide

But you are not alone as your hoverboard is also not charging. It is one of the most widespread problems of those who have hoverboards. That is why in this instructional guide we will take you through all the possible causes why your hoverboard is not charging, along with diagnostic steps and the course of actions you can undertake to get your hoverboard charging once more.

Why Is My Hoverboard Not Charging?

Your hoverboard can fail to charge because of a few technical, mechanical, or environmental factors. These include:

  • Broken charging slot
  • Faulty charger
  • Damaged battery or dead battery
  • Problems with internal wiring
  • Software malfunction
  • Overheating mode
  • BMS (Battery Management System) lock

Before you can get your hoverboard functional again, our first step is to find the source of the problem.

Check the Charger First

Is Your Hoverboard Charger Life?

This is most likely to be a malfunctioning charger. First, you need to insert your hoverboard charger in a protruding and look at the LED signal:

Red light: Charger is charging actively

Green light: not connected or fully charged battery

No light: Charger is faulty or has no electricity supply

See whether you can test the charger on a different hoverboard. Alternatively, use a multimeter to measure the final voltage, and ensure that it equals that within the specification (usually 42V on a 36V hoverboard).

Check the Charging Port

Is there a Damage in the Charging Port?

Inspect the charging port for physical damage or any form of debris. The three-pin connector has to be properly aligned, and tightened.

  • Broken or bent pins have the potential to block the connection between the charger.
  • Internal connections can be loose, and it could need resoldering by a technician.
  • Any dust or dirt inserted in the port should be blown out using compressed air.

Look at the Battery Condition

Did your Hoverboard Battery Die or Fail?

In case both spots are not working, then the battery pack might be the problem.

Symptoms of bad battery:

  • After charging, Hoverboard switches off easily
  • On powering on, no lights as far as I could detect.
  • Battery is bloated or swollen
  • Continuous beep by hoverboard

Test the voltage of the battery using a multimeter. A 36V lithium-ion battery will measure about 36-42V when fully charged. When it is too low, it could cause the battery to be discharged forever.

Hard Reset

Hoverboard Battery Reset

Occasionally, the breakdowns in the internal systems can be caused by a software glitch or a power surge. You will work this out by doing Hard Reset:

  • Switch off the hoverboard
  • Press and hold the power key 1015 secs
  • Wait until you listen to a beep and observe flashing lights
  • Press the button down and allow the hoverboard to rest in powered-off condition 5 minutes
  • Plug back the charger and see whether it resumes charging

This has the capability of correcting errors of power cycle and BMS locks.

Develop Indicators of Overheat

Is the Hoverboard overheating when Charging?

In the event that you have been using your hover board intensively or you have been using it in hot weather outdoors, it may trigger the thermal protective mechanism. When the battery management system turns off charging temporarily, it is to avoid overheating.

  • Do not use anywhere from 30-60 minutes to allow the hoverboard to cool down
  • Keep it in a room that is cool and well ventilated
  • Then repeat charging, once temperature is stable
  • Do not charge immediately after a ride.

The Internal Wiring test (IV)Check

Loose or Burnt Wiring Can Interrupt Charging

You should disassemble your hoverboard carefully. In case you feel at ease with electronics, screw open the bottom shell and have a look at the interior parts:

  • Check burn marks, loosely hanging wires and broken solder joints
  • Ensure that battery plugs are well inserted into circuit board
  • Make sure there is no corrosion or water damages

In case there are visible markings of damage in the internal wires, it is advisable to change them or consult a hoverboard technician. 

Battery Management System (BMS) Lock

The Hoverboard May Be in Lock Mode

In case you have left your hoverboard battery discharged too long, the battery might get locked by the BMS in an attempt to protect it. This implies that you can plug it in and it will not take any charge.

Solution:

  • Carefully use an external charger referred to as a jump starter to increase the voltage.
  • This will make the battery come to life and start its regular charging.
  • CAUTION: This practice is to be applied by qualified professionals or be carried out professionally.

Exchange a New Battery

How To Change a Hoverboard Battery?

In case your hoverboard is more than 2-3 years old or was wet, the battery will be degraded. Symptoms include:

  • Hoverboard can not be charged beyond a certain point
  • The percentages of battery drain in a short period of time are lower when it is used
  • Several beeping-type of mistakes

Exchange with the same model or similar batteries such as 36V 4.4Ah or 4.0Ah lithium-ion battery. Ensure that the substitute is safety-certified as well as safety-tested.

The Way to Avoid Gravity Board Powering Problems

Hoverboard battery health best practices

To prevent future problems of charging, use these tips:

  • Don not go deep in discharges: Recharge before entering the battery to 0%
  • Property overcharging – Remove the plug once it has been charged to the end
  • Charge at cool temperatures- No extreme weather

Keep it dry, please – Water is the biggest enemy of electronic equipment. Original charger is always better Or there is a danger of damaging the battery with such cheap third-party chargers

Final Thoughts

As much as charging a hoverboard may be a frustrating process, most charges are simple to repair as soon as you understand where to seek resolutions. Starting with verifying the charger all the way to troubleshooting the battery, the article offers a troubleshooting approach in a step by step process. When you experience chronic problems, it might be advised to reinforce your battery or have it fixed by an expert.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *